ER5000 —
60
Getting Started
1
Verify your shipment
CAUTION
If you are replacing an ER3000 in an existing application, be
sure that you have read Replacing an ER3000 with an ER5000
before you begin.
WARNING
If you are replacing a Hazardous Location ER3000 in an existing
application, be sure that you have read Installing a Hazardous
Location
Model (ER5050) on page 110 before you begin.
Verify that all of these items are in the box you receive.
1. ER5000 or ER5050 Hazardous Location Electronic
Pressure Controller
2. 3mm hex wrench for cover lock screw (ER5050 model only)
3. 1/2" SAE x 1/8" NPTF adaptor
4. Wiring connectors, pre-installed with strain relief
a. 12-pin MTA connector with 12-wire
18" / 45.7 cm cable (standard ER5000 models)
b. 12-pin and 8-pin MTA connectors with single 20-wire
18" / 45.7 cm cable (“F” model ER5000s)
5. USB cable with integrated strain relief (ER5000 models only)
1
3
4a
4b
5
Figure 6: What’s In The Box
2
To Next Page
Loading...
Need help?
General
