Envoy Installation and Operation
2014 Enphase Energy Inc. 141-00011 Rev 05
2. Register the Envoy
Register the Envoy at the beginning
of the PV installation.
a. Use your previously issued
username and password to log in
to in Enlighten.
If you haven’t registered, go to
www.enphase.com and click
Enlighten Login.
b. At the installer dashboard, click
Add a New System.
If you have already registered the
site, find the system under
Installations in Progress.
c. Under System, enter the system
Name, Type and Installer
Reference (optional).
d. Enter Installer information.
e. Under Owner, enter the Name,
Email, and Phone.
f. Under Location, enter the
Country and address information.
g. Under Envoy, select the Internet
Connection type and enter the
Envoy Serial Number.
NOTE: If you have selected a
country other than the US, or
if you select Hawaii as the
state under Location, the
Grid Profile menu appears.
h. If required, select the appropriate
profile from the Grid Profile
menu. Skip this step in the
continental US because the
factory settings meet
requirements.
i. Under Modules, enter total
number of modules, type, etc.
NOTE: For more information
on Grid Profiles, see “Set or
Change the Grid Profile” on
page 41.
NOTE: If you need to change
the grid profile subsequent to
this initial procedure, follow
the steps in “Set or Change
the Grid Profile” on page 41.
j. Click Save to submit the form.
You will receive a confirmation
message: “Activation Created
Successfully.”
To Next Page
Loading...
Need help?
General