Mounting the 8 Port Switches
Enterasys 800-Series Hardware Installation Guide 2-13
Figure 2-10 Installing the Switch On a Wall
To install the switch in the wall mount kit and then install it on a wall, refer to Figure 2-10 and
proceed as follows:
1. Ensure that you have appropriate screws for securing the assembled wall mount kit to your
wall location. These four screws are required and are not provided in the wall mount kit.
2. Mount the switch on the front side of the wall mount kit in the direction shown, aligning the
three screw holes on the bottom of the unit with the three holes in the wall mount tray.
3. Using the screws provided, secure the switch to the wall mount tray.
4. If installing an optional RPS, install the power supply by sliding it under the flange located on
the bottom side of the wallmount tray.
5. Using the Velcro strap provided, thread the strap through the mounting tray and over the
power supply in the following order:
a. Up through the mounting tray bracket at the side of the power supply
b. Through the opening in the mounting tray flange
1 Wall mounting screw holes (four) 7 Optional RPS
2 Switch mounting screw holes (three) 8 Power supply mounting flange
3 AC power receptacle 9 Power supply mounting bracket
4 Fan tab 10 Power supply Velcro strap
5 Serial number access window 11 AC power cord
6 DC power cord
Note: Ensure that the switch is secured to the wall mount tray in the position shown, with the front
panel of the switch facing downward. The fan tab on the wall mount tray must face downward when
the kit is installed on the wall.
To Next Page
Loading...
Need help?
General