162
Uninstall Your Product Software
Power Cleaning
Related references
Where to Get Help
Resetting Network Settings
You can reset the network settings to their factory defaults.
1. Turn off your product.
2. Hold down the network status button and press the power button until the Wi-Fi light and
Wi-Fi Direct light flash alternately. Then release both buttons.
When the Wi-Fi light and Wi-Fi Direct light turn off, the Wi-Fi settings are reset.
Parent topic: Solving Problems
Solving Setup Problems
Check these sections if you have problems while setting up your product.
Product Does Not Turn On or Off
Noise After Filling the Ink
Software Installation Problems
Parent topic: Solving Problems
Product Does Not Turn On or Off
If you cannot turn the product on or off, try these solutions:
• If you cannot turn on your product, make sure the power cord is securely connected and hold down
the power button a little longer.
• If you cannot turn off your product, hold down the power button a little longer. If you still cannot turn off
your product, unplug the power cord, plug the power cord back in, then turn your product on and off
again using the power button.
Parent topic: Solving Setup Problems
To Next Page
Loading...
Need help?
General
