16
Adjusting the Projection Position (Image Shift)
Adjusting the Projection Position (Image Shift)
When you cannot setup this projector directly in front of the screen, the
projection position can be finely tuned without moving this projector.
1 Using the button on the projector, perform zoom adjustment or
keystone correction. See the Quick Setup sheet.
The Image Shift adjustment screen is displayed after you finish
making adjustments.
2 Adjust projection position.
3 Press the [Esc] button to close the adjustment screen.
The screen closes automatically if no operations are performed for
about 10 seconds.
p
• The projection position cannot be adjusted when zoom is set to
maximum "wide".
• Even if you turn the power supply off, the "Image Shift" settings you
make are kept. When either the projector position or the angle of the
projector is changed, you can readjust or perform the following
operations.
• You can also make adjustments from the configuration menu. See page
33.
Using the Remote Control Using the Control Panel
Press and hold down the
[Wide] and [Tele] buttons
for more than one second.
Control Panel
To Next Page
Loading...
Need help?
General
Weight and Dimensions
