43
Replacing Consumables
Resetting the Lamp Operating Time
The projector has a built-in counter which keeps track of the lamp operating
time. When the cumulative operating time reaches a certain point, it causes
the replacement warning message to be displayed. The counter needs to be
reset after the lamp has been replaced with a new one. You can do this using
the configuration menu.
1 Connect the power cable and turn on the projector.
2 Select "Reset" from the configuration menu, and then select
"Reset Lamp Hours".
Check the buttons you can use, and the operations they perform, in
the guide at the bottom of the screen.
3 When "Execute?" appears, select "Yes".
The lamp operating time will then be reset.
p
Do not reset the lamp operating time except after the lamp has been
replaced, otherwise the lamp replacement period will not be indicated
correctly.
Using the remote control
Using the control panel
To Next Page
Loading...
Need help?
General
Weight and Dimensions
