EasyManuals Logo
Home>Epson>Projector>PowerLite S4

Epson PowerLite S4 User Manual

Epson PowerLite S4
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
44
Replacing Consumables
Replacing the Air Filter
If the air filter is broken or if a warning message reappears after it has been
cleaned, it should be replaced.
The air filter can be replaced even if the projector is installed on a ceiling.
1 Turn off the projector’s power, wait until it beeps twice, and
disconnect the power cable.
2 Remove the air filter.
Put your finger into the recess of the air filter and slide it out to remove
it.
3 Install the new air filter.
Slide in the new air filter and press until it clicks into place.
Recess
p
Dispose of used air filters properly in accordance with your local
regulations.
Air filter frame: Polycarbonate, ABS plastic
Filter: Polyurethane foam

Table of Contents

Other manuals for Epson PowerLite S4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson PowerLite S4 and is the answer not in the manual?

Epson PowerLite S4 Specifications

General IconGeneral
Number of colors16.78 million colors
Projection distance6 m
Vertical scan range48 - 85 Hz
Horizontal scan range15 - 92 kHz
Projection technologyLCD
Contrast ratio (typical)500:1
Screen size compatibility30 - 300 \
Projector native resolutionSVGA (800x600)
Keystone correction, vertical-30 - 30 °
Lamp typeUHE
Lamp power170 W
Light source typeLamp
Service life of light source2000 h
Service life of light source (economic mode)3000 h
FocusManual
Focal length range16.6 mm
InterfaceUSB
Audio inputRCA x 2
Dimensions (WxDxH)246 x 328 x 100 mm
Power requirements100-240 V +/- 10%, 50/60 Hz AC
Connectivity technologyWired
Noise level36 dB
Dot clock scanning frequency162 MHz
RMS rated power1 W
Number of built-in speakers1
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (standby)5 W
Power consumption (typical)250 W
Operating temperature (T-T)5 - 35 °C
Weight and Dimensions IconWeight and Dimensions
Weight2600 g

Related product manuals