SE Group Confidential (Related Staff Only)
Adjustment Details of Adjustments 54
SC-P600 Revision D
2.3.6 Initial setting
Setting procedure
1. After replacing the Main Board, note down the MAC address written on a label on the Shield Plate Lower.
2. Connect the printer and the PC with the USB cable.
3. Start the Adjustment Program.
4. Select the “Initial Setting” from the menu. The initial setting screen appears.
5. Click the check boxes you need to perform the initial setting.
6. Input the last 6 digits on mac address into the blanks. (If you need to input full mac address, Click Full Input.)
7. Press Perform button and make sure the configuration is proper by Pressing Check button.
Figure 2-23. Initial setting Screen
This setting is not necessary when the data in EEPROM on the Main Board can be read out.
To avoid a conflict of MAC address on a network, make sure to correctly follow the MAC
address setting flowchart given on the following.
The user should be notified of the change of MAC address because of the following reasons.
• If the user has set the printer’s MAC address on a router, the repaired printer with a
new MAC address cannot be connected to the network.
• The default printer name on a network consists of “EPSON” and the last six digits of the
MAC address. Therefore, the printer name becomes different from the previous one.
You are required to enter the last six digits of the MAC address (xx:yy:zz) on the
Adjustment Program.
MAC address example: 00:00:48:xx:yy:zz
(“xx, yy, zz” represents a value unique to each printer)
Figure 2-22. MAC Address Label
MAC Address Label
Last six digits of MAC address
Shield Plate Lower
To Next Page
Loading...
Need help?
General