Epson Stylus C67 Service Manual

EPSON Stylus C67/C68/D68 Revision A
PRODUCT DESCRIPTION Operator Controls 15
1.3.3 Printer Condition and LED Status
Note *: When the reset request (e.g. IEEE 1284.4 “rs” command, Parallel Init signal)
occurred, the LED indicates for 0.2 sec.
1.3.4 Errors
Printer status
Indicators
Priority
Power LED Paper LED Ink LED
Power on On -- -- 11
Ink level low -- -- Flashes 10
Data processing Flashes -- -- 9
No ink cartridge or ink end -- -- On 8
CSIC Error -- -- On 8
Ink sequence Flashes -- -- 7
Ink cartridge change mode Flashes -- -- 6
Paper out -- On -- 5
Paper jam condition -- Flashes -- 4
Maintenance request
Off
Flashes
alternately
Flashes
alternately
3
Fatal error Off Flashes on
high speed
Flashes on
high speed
2
Power off Flashes on
high speed
Off Off 1
Reset request
*
On On On --
Table 1-7. Error Status
Error Description
Ink out
When the printer runs out the most part of the ink of any one color,
it warns ink-low and keeps printing.When the printer runs out the
whole ink of any one color, it stops printing and indicates ink-out
error. User is requested to install a new ink-cartridge in this state.
Paper out When printer fails to load a sheet, it goes paper out error.
Paper jam When printer fails to eject a sheet, it goes paper jam error.
No ink-cartridge / CSIC
Error
When printer detects that ink-cartridge comes off, or failed to read
or write CSIC data, it goes this error mode.
Maintenance request
When the total quantity of ink wasted through the cleanings and
flushing is reaches to the limit, printer indicates this error and
stops. The absorber in the printer enclosure is needed to be
replaced with new one by a service person.
Fatal errors Carriage control error.
Table 1-7. Error Status
Error Description

Epson Stylus C67 Specifications

General

Brand	Epson
Model	Stylus C67
Category	Printer
Language	English