This chapter explains all the options in the HOUSE SETUP menu.
In HOUSE SETUP select the parts of the control computer you intend to use. The control computer will only
display data relevant to you in the screens. Parts not used, will not be shown. Most codes are self explanatory.
HOUSE SETUP tab page Inside
Setting of the number of heating units to be used.
Setting of the number of cooling units to be used.
Setting indicating if pressure measurement is used. If pressure measurement is used,
the pressure can influence exhaust ventilation or air inlets (YES/NO).
Setting indicating if RH measurement is used. If RH measurement is used, the RH
influence on heating, cooling and ventilation can be used.
Setting indicating if humidity control is used. This can only be used in combination with
RH-measurement.
Setting indicating if CO
2
(carbon dioxide) or NH
3
(ammonia) measurement is used. If
CO
2
or NH
3
measurement is used, its influence on ventilation can be used.
Setting of the partial inlet control, whereby only some of the inlets are controlled. The
control will be corrected.
Setting of the number of minivents used in the house. This is mainly important with air
inlets.
Setting of the partial use of available house space.
Setting of the number of minivents used during Half-House Brooding.
Setting indicating if stir fans are used.
To Next Page
Loading...
General