Fancom LUMINA 16 User Manual

Lumina 16
Installer
48
Amount per min.
*
Setting of the number of 'units' measured per minute. This option is only available if
Display=AMOUNT. (only with measurement type: CONTACT)
Display amount
*
Setting how the unit is displayed:
 AMOUNT: number 'units' per minute (Amount per min.).
 TIME: the time the contact makes contact. (only with measurement type:
CONTACT)
Amount today
Readout of the unit measured today. Reset this value to start all registration from zero
again.
Input status
*
Readout of the actual input status. HIGH or LOW. (only with measurement type:
CONTACT)
The control computer requires input from several sensors to determine the climate in the house.
INSTALLER  INSIDE CLIMATE
Temp. inputs
Setting of the analog temperature inputs. If the H option behind the address of the input
is selected, half house brooding is activated for this section.
Pressure input
Setting the address of the analog input.
Block pressure influence
Setting to block the pressure influence (e.g. Free Range House)
Speed press. contr.
Setting of the speed at which the control computer determines influences (SLOW /
MODERATE / FAST).
Input <x> measurement
where x is RH, NH3 or
CO2
Setting the address of the analog input.
Speed <x> control
where x is RH, NH3 or
CO2
Setting of the speed at which the control computer determines influences (SLOW /
MODERATE / FAST).

Fancom LUMINA 16 Specifications

General

Brand	Fancom
Model	LUMINA 16
Category	Desktop
Language	English