Notices
26
FCC Notice: This device complies with Part 15, subpart C, of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by unauthor-
ized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment. However, it is imperative that the user follows the guidelines in
this manual to avoid improper usage which may result in damage to the unit, electrical
shock and fire hazard injury.
Changes or modifications made to this equipment not expressly approved by FLIR Sys-
tems, Inc. may void the FCC authorization to operate this equipment.
Radio Frequency Exposure: The radiated output power of the device is below the
FCC/ IC radio frequency exposure limits. Nevertheless, the device shall be used in such
a manner that the potential for human contact during normal operation is minimized.
FCC/IC: This device complies with Part 15 of the FCC Rules and with RSS-210 of Indus-
try Canada. Operation is subject to the following two conditions: 1. This device may not
cause harmful interference, and 2. This device must accept any interference received, in-
cluding interference that may cause undesired operation.
Exposition aux radiofréquences : La puissance de sortie rayonnée de l'appareil est in-
férieure aux limites d'exposition de radiofréquences de la FCC/IC. Néanmoins, le dispo-
sitif doit être utilisé de telle manière que le niveau de contact avec un être humain soit
réduit au minimum pendant une utilisation normale.
FCC/IC: Ce dispositif est conforme à la section 15 des réglementations de la FCC et à la
norme RSS-210 d'Industrie Canada. Son fonctionnement est soumis aux deux condi-
tions suivantes : 1. Ce dispositif ne doit pas causer d'interférences nuisibles, et 2. Ce dis-
positif doit accepter toute interférence reçue, y compris les interférences qui peuvent
provoquer un fonctionnement indésirable.
CE: This device complies with the essential requirements of the R&TTE Directive 1999/
5/EC. The following test methods have been applied in order to prove presumption of
conformity with the essential requirements of the R&TTE Directive:
• EMI/EMC Directive 2004/108/EC - Electromagnetic Compatibility
• WEEE Directive 2012/19/EU - Waste Electrical and Electronic Equipment
• LVD Directive 2006/95/EC - Low Voltage Directive
• Battery Directive 2006/66/EC - Batteries and accumulators and waste batteries and
accumulators
• ErP Directive 2009/125/EC - on the Eco-Design requirements of Energy-related
Products
• RoHS2 Directive 2011/65/EC - Restriction on the use of certain Hazardous
Substances
Disposal: As with most electronic products, this equipment must be disposed of in an
environmentally friendly way, and in accordance with existing regulations for electronic
waste. Please contact your FLIR Systems, Inc. representative for more details.
To Next Page
Loading...
Need help?
General
