Note: Make sure that the wiper blade locks
into place.
ADJUSTING THE HEADLAMPS
You can adjust the headlamp beams for
when you drive on the right-hand side or
left-hand side of the road.
1. Remove the headlamps. See
Removing a Headlamp (page 161).
2. Remove the covers. See Changing a
Bulb (page 162).
3. Slide the control on each headlamp to
adjust the headlamp beam.
Note: When you return to driving on the
other side of the road, remember to change
the headlamp beams to the original setting.
REMOVING A HEADLAMP
1. Open the hood. See Opening and
Closing the Hood (page 152).
2. Remove the screws and push pins.
3. Lift the outer side of the headlamp to
disengage it from the lower fixing point.
4. Pull the headlamp as far as possible
toward the center of your vehicle and
remove.
5. Disconnect the two electrical
connectors.
Note: When fitting the headlamp, make
sure that you reconnect the electrical
connector correctly.
161
B-MAX (CB2) Vehicles Built From: 25-06-2012, Vehicles Built Up To: 31-12-2013
Maintenance
To Next Page
Loading...
Need help?
General
