• Park your vehicle at the roadside so
that you do not obstruct the flow of
traffic and so that you are able to use
the kit without being in danger.
• Apply the parking brake, even if you
have parked on a level road, to make
sure that your vehicle will not move.
• Do not attempt to remove foreign
objects like nails or screws penetrating
the tire.
• Leave the engine running while the kit
is in use, but not if your vehicle is in an
enclosed or poorly ventilated area (e.g,
inside a building). In these
circumstances, switch the compressor
on with the engine switched off.
• You must replace the sealant bottle
with a new one before the expiry date
(see top of bottle).
• Inform all other users of your vehicle
that the tire has been temporarily
sealed with the kit. Make them aware
of the special driving conditions that
must be observed.
Inflating the Tire
WARNINGS
Check the sidewall of the tire prior to
inflation. If there are any cracks,
bumps or similar damage, do not
attempt to inflate the tire.
Do not stand directly beside the tire
while the compressor is operating.
Watch the sidewall of the tire. If any
cracks, bumps or similar damage
appears, switch off the compressor
and let the air out by means of the pressure
relief valve I. Do not continue driving with
this tire.
The sealant contains natural rubber
latex. Avoid contact with skin and
clothing. If this happens, rinse the
affected areas immediately with plenty of
water and contact a Physician.
WARNINGS
If the tire inflation pressure does not
reach 26 psi (1.8 bar) within 10
minutes, the tire may have suffered
excessive damage, making a temporary
repair impossible. Do not continue driving
with this tire.
LabelA
Sealant bottleB
Sealant bottle hoseC
Bottle holderD
Pressure gaugeE
Power plug with cableF
Compressor switchG
175
B-MAX (CB2) Vehicles Built From: 25-06-2012, Vehicles Built Up To: 31-12-2013
Wheels and Tires
To Next Page
Loading...
Need help?
General
