Safety Notes
27
Before Using the Machine
1
5 Press the <TEST> button lightly with a
sharp edge such as a pen tip. The depressed
<RESET> button will stick out again. This is
the end of the check procedure.
6 Press the <RESET> button back to the depressed position.
If the circuit does not work properly, contact your local Fuji Xerox representative.
Do not attempt to remove a paper deeply jammed inside the product,
particularly a paper wrapped around the fusing unit or the heat roller.
Otherwise, it may cause injuries or burns. Switch off the product
immediately and contact your local Fuji Xerox representative.
Never touch the paper output area of the finisher during operation. It may
cause injuries.
Be careful in removing jammed staples.
Do not apply excessive force to hold thick document on the document glass.
It may break the glass and cause injuries.
To move this product to another location, contact your local Fuji Xerox
representative.
Ventilate well during extended operation or mass copying. It may affect
the office air environment due to odor such as ozone in a poorly ventilated
room.
Provide proper ventilation to ensure the comfortable and safe environment.
When you use earphones, adjust the volume. Loud sound may cause
hearing loss.
To Next Page
Loading...
Need help?
General
