Fuji Xerox DocuPrint M215 b User Manual

Using the Operator Panel Menus and Keypad 354
• Low Toner Alert Msg
Purpose:
To specify whether to show the alert message when the toner is low.
Values:
•Power On Wizard
Purpose:
To perform initial settings for the printer.
See also:
• "Setting Initial Settings on the Operator Panel" on page 50
Values:
Maintenance
Use the Maintenance menu to initialize Non-Volatile Memory (NVM), configure the paper type
adjustment settings, and configure the security settings.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• F/W Version
Purpose:
To display the version of the controller.
• Adjust BTR
Purpose:
To specify the optimum voltage settings for printing for the transfer roller (BTR). To lower the voltage,
set negative values. To increase, set positive values.
The default settings may not give the best output on all paper types. If you see mottles on the print
output, try to increase the voltage. If you see white spots on the print output, try to decrease the
voltage.
NOTE:
• The print quality changes depending on the values you select for this item.
Values:
Off Does not show the alert message when the toner is low.
On * Shows the alert message when the toner is low.
Yes Performs the initial settings for the printer.
No * Does not perform the initial settings for the printer.
Plain 0*
-3 – +3
Light Card 0*
-3 – +3

Fuji Xerox DocuPrint M215 b Specifications

General

Brand	Fuji Xerox
Model	DocuPrint M215 b
Category	All in One Printer
Language	English