3. ADJUSTMENTS
3-14
3.8 Display Unit Setting
3.8.1 MU-150HD
How to turn the power on/off
The external equipment connected to the DVI port (DVI-D1 or DVI-D2) can power the
display unit on/off.
Slide switch
• ON (upward): Allow the digital signal from
external equipment to control the on/off of
the display unit.
• OFF (downward): Set to this position for
analog RGB signal.
Note: Turn the slide switch OFF to connect
equipment to both DVI and RBG ports.
How to adjust the brilliance from external equipment
You can set the brilliance control on the [SYSTEM] menu. Also, you can check the sig-
nal status and the program number on the [SYSTEM] menu.
1. Press the MENU key to show the main menu.
2. Press the X key to select [SYSTEM]. The message "Input Signal Searching.
Please Wait." appears and then the [SYSTEM] menu is displayed, as shown in the
right figure.
3. Press the S or T key to select [AUTO DIMMER]
4. Press the W or X key to select [OFF].
5. Press the S or T key to select [EXT BRIL CTRL].
6. Press the W or X key to select [DVI1] or [DVI2].
7. Press the MENU key to close the menu.
Upward: Default setting
(Slide switch ON)
Upward: Default setting
(Slide switch ON)
Downward
(Slide switch OFF)
Downward
(Slide switch OFF)
Signal status
and Program
number
To Next Page
Loading...
Need help?
General
