5. VIDEO PLOTTER OPERATION
5-4
5.4.2 How to select the mark color (B/W-type only)
type radars of this series allow the change of mark colors. For all other types, the color
is fixed and cannot be changed.
1. Open the menu.
2. Select [2 MARKS].
For B/W-types with Radar Plotter functionality, this menu appears as [2
MARKS•CHART].
3. Select [5 RADAR MAP].
The [RADAR MAP] menu appears.
Note: You can also right-click the [MARK] box to open the [RADAR MAP] menu.
4. Select [0 NEXT] to show the next menu page.
5. Select [3 MARK COLOR].
6. Select the appropriate color. Available options are shown in the table below.
7. Close the menu.
5.4.3 How to inscribe marks
You can inscribe marks anywhere inside the operational display area, however, marks
cannot be inscribed in the same location as a menu box.
Depending on the setting for [4 MARK POSITION] the method to inscribe a mark is
slightly different.
Where [4 MARK POSITION] is set to [CURSOR]
1. Referring to section 5.2, select the mark type you want to use.
2. Place the cursor on the [MARK] box, at the bottom-left of the screen.
3. Spin the scrollwheel to select the appropriate mark, then left-click. The cursor
moves inside the operational display area.
4. Place the cursor on the location (inside the operational display area) you wish to
inscribe the mark, then left-click to anchor the mark.
5. Repeat steps 3 to 4 for multiple mark inscription.
6. Right-click to complete the procedure.
Where [4 MARK POSITION] is set to [OWN SHIP]
1. Referring to section 5.2, select the mark type you want to use.
2. Place the cursor on the [MARK] box, at the bottom-left of the screen.
3. Spin the scrollwheel to select the appropriate mark, then left-click. The selected
mark is inscribed at the OS position.
4. Repeat steps 1 to 2 for multiple mark inscription, or right-click to complete the pro-
cedure.
Menu
indication
Color
Menu
indication
Color
Menu
indication
Color
RED Red CYA Cyan BLU Blue
GRN Green MAG Magenta YEL Yellow
WHT White
To Next Page
Loading...
Need help?
General
