4. TT OPERATION
4-6
3. Select [Vector Time], then press the ENTER key.
4. Select time, then press the ENTER key.
5. Select [Vector Reference], then press the ENTER key.
6. Select [Relative] or [True] then press the ENTER key.
[Relative]: Other ships’ vectors are displayed relative to your ship. This mode
helps find targets on a collision course. If a ship is on a collision course with your
ship, the vector of a ship points toward your ship position.
[True]: Your ship’s and other ships’ vectors are displayed at their true motions.
This mode helps discriminate between moving and stationary targets.
Note: Heading data and own ship speed data are required for setting [True].
7. Press the MENU key to close the menu.
Note: The functions of the [Target] menu are shared by TT and AIS.
4.8.3 Own ship vector
The vector of own ship is shown as an arrow from your ship position. The vector of
own ship is shown on the following conditions:
• Select [True] on the menu item [Vector Reference] on the [Target] menu.
Note 1: The vector of own ship is shown in the same color as the TT symbol color.
Note 2: Heading data and own ship speed data are required to set [Vector Reference].
+
02
Data box
Own ship
vector
Cursor
To Next Page
Loading...
Need help?
General
