2. OPERATION
2-49
2. Press or to select [Initial], then press the ENTER key.
2.37.2 Description of Initial sub menu
[Key Beep]: When a key is pressed, a beep sounds. You can turn on or off this beep.
[Compass Type]: Select the type of bearing sensor connected to the radar; [True] (gy-
rocompass, satellite compass) or [Magnetic] (magnetic compass).
[Range Preset]: You can select the radar ranges. Select a range, then press the EN-
TER key to switch on and off. At least two ranges must be turned on. The maximum
range available depends on the radar model.
[NMEA Port 1]: Set the baud rate of the equipment connected to Port 1 ([Auto], [4800],
or [38400] (bps)). [Auto] provides automatic detection of baud rate from 4800, 9600,
19200 or 38400 (bps).
[NMEA Port 2]: Same function as Port 1 but for Port 2.
[NMEA Port 3]: Same function as Port 1 but for Port 3.
Note 1: For initial settings of the SCX-21, connect the SCX-21 to NMEA Port 1 in order
to reflect the rules when the FR-10/12 and SCX-21 are connected.
Note 2: FR-10/12 does not use the software to forcibly switch the communication
speed when the SCX-21 is connected. When connecting the SCX-21, set the commu-
nication speed to 38400bps.
[NMEA Mixing Out]: Data input to Port 1 may be output from Port 2 mixed with data
output to Port 2. Select [On] to use this feature.
[Mouse Assignment]: Select the function for the button of USB mouse ([Range] or
[Target]). When select [Range], the mouse operates under simple mode and when se-
lect [Target], the mouse operates under full mode (see below table for difference).
Mode/Function Simple mode Full mode
Range Regardless of the cursor
position, left-click to narrow
the distance range, and
right-click to widen it.
Continuous range change
by pressing and holding left
button and right button
does not work.
Left-click on the RANGE
icon to narrow the distance
range, and right-click to
widen it.
Continuous range change
by pressing and holding left
button and right button
does not work.
To Next Page
Loading...
Need help?
General
