2. OPERATION
2-2
2.2 How to Turn the Radar On/Off
Press the ( /BRILL) key to turn on the radar. To turn off the radar, press and hold
down the key until the screen turns off.
When you turn on the power, the initializing screen is shown, the preparation screen
will appear after about 5 seconds, and the time to warm the magnetron will start count-
ing on the screen. Its time is 90 seconds.
Note 1: When the DRS2D/4D/6A/12A/25A-NXT is connected, transmission can start
soon after showing the initializing screen.
Note 2: When you turn off the power during the transmission, the radar sensor switch-
es to STBY mode for safety. It is advised to turn off the radar sensor from the switch-
board as soon as possible.
2.3 TX/Standby
After the magnetron has warmed (the time to warm the magnetron is not required on
the NXT series radar), the indication [STBY] appears at the screen center. The radar
is now ready to transmit radar pulses.
To switch between TX and standby, push the STBY/TX
key.
The antenna rotates in transmit and is stopped in standby.
Note: The display unit supplies “standby power” to the antenna unit when the display
unit is turned off. If use of the radar is not required for an extended period, shut off the
radar at the breaker.
*
Nowinitializing...
ー注意−
本機器に表示される情報は法令で船舶に
備えなければならない電子海図ではなく、
あくまで参考のものです。
航海の為の詳細な情報及び最新の情報に
ついては、海図及びその他の航海用
刊行物を参照してください。
また、本装置に表示される潮汐情報も、
参考のものとなっています。
航海には必ず、海上保安庁刊行の潮汐表
を使用してください。
いずれかのキーを押してください。
*: These messages are shown when the
optional RP board is installed on the display unit.
*
20222501
To Next Page
Loading...
Need help?
General
