2. OPERATION
2-6
[TT Advanced]: Set up the TT (Target Tracking).
[AIS]: Set up the AIS.
[Radio]: Set up the radio communication equipment (see chapter 6).
[Chart]: Set up the chart (available only for FR-10 with RP board installed, see
chapter 7).
[System]:
- [Initial]: Initial settings.
- [Files]: Set up the setting files.
- [Tests]: System diagnostic and LCD test.
- [Sector Blanks]: Prevent the transmission in a certain area.
- [Units]: Set up units of measurement.
- [TT]: Set up TT system. For the installer. Do not change the settings.
- [SCX-20]: Set up the SCX-20.
- [SCX-21]: Set up the SCX-21.
- [Installation]: For installation.
- [Factory]: For installation.
3. Press the ENTER key to switch the control to the menu items column. The cursor
in the menu column now turns gray and the cursor in the menu items column is
yellow.
To switch control from the menu items column to the menu column, use the MENU
key. The color of the title bar of the active column is blue and the inactive column
is gray.
4. Select a menu item, then press the ENTER key. A window with options for the re-
lated menu item appears.
5. Press or on the cursorpad to select an option or set a numeric value.
6. Press the ENTER key to save your selection. To close the window without saving,
press the MENU key.
7. Press the MENU key to close the menu.
To Next Page
Loading...
Need help?
General
