S2E-17-0208_OM_WR2120_C
77
6.2. Remote Control
1) Click [CONNECT] after entered the target ID of host
when access to the host side from the local pc.
2) Enter the password that set on the host side when it
asked the password after accessed.
3) When the PC screen on the host side is displayed, it
can operate in the same way as when using an
ordinary PC.
4) Close the window by clicking one of the [X] for the following
three locations on the screen for disconnecting the host
side.
Caution: Never click “Exit TeamViewer” from the TeamViewer icon from the host side task bar. If you exit
TeamViewer on the host side, you have to go to the site unless there is no PC connected to the
site that possible to control using the remote access.
Click any of these to close TeamViewer
To Next Page
Loading...
Need help?
General
