FUTABA 10J User Manual

Beforeuse
28
0RGH6ZLWFK
Use the small plastic screw driver that was
included with your receiver.
Switch is also used for the CH mode selection.
5HFHLYHU56%
&RQQHFWRU
"1 through 6": outputs for the channels 1
through 6
"7/B": outputs of 7 channels and power.
"8/SB": outputs of 8 channels or S.BUS port.
>6%866HUYR6%86*\UR@
:KHQXVLQJ6%DV6%86\RXKDYHWRVHW
CH MODE of the following page to mode B or
mode D.
"S.BUS2": outputs of S.BUS2 port.
>6%866HUYR6%86*\UR7HOHPHWU\6HQVRU@
:KHQXVLQJRUPRUHFKDQQHOVXVHDQ6%86
function or use a second R3008SB and link both
to your transmitter.
&RQQHFWRULQVHUWLRQ
Firmly insert the connector in the direction
VKRZQLQWKH¿JXUH,QVHUWWKH6%86E\WXUQLQJ
it 90 degrees.
＋
−
5HFHLYHU
Danger
Do not connect either a switch
or battery in this manner.
'DQJHU
'RQWFRQQHFWDFRQQHFWRUDVVKRZQLQD
EHIRUH¿JXUH
,WZLOOVKRUWFLUFXLWLIFRQQHFWHGLQWKLVZD\$VKRUWFLUFXLW
DFURVVWKHEDWWHU\WHUPLQDOVPD\FDXVHDEQRUPDOKHDWLQJ
¿UHDQGEXUQV
'RQWFRQQHFWVHUYRIRUFRQYHQWLRQDO
V\VWHPWR6%866%86SRUW
'LJLWDOVHUYRIRUFRQYHQWLRQDOV\VWHPĺ,WGRHVQRWRSHUDWH
$QDORJVHUYRĺ,WPD\FDXVHDEQRUPDOKHDW¿UHDQGEXUQLQJ
:DUQLQJ
6%86FRQQHFWRUV
'RQWFRQQHFWDQ6%86VHUYRJ\URWR
6%86FRQQHFWRU
/('0RQLWRU
This monitor is used to check the CH mode of
the receiver.
RECEIVERNOMENCLATURE
%HIRUHXVLQJWKHUHFHLYHUEHVXUHWRUHDGWKHSUHFDXWLRQVOLVWHGLQ
the following pages.
([WUD9ROWDJH&RQQHFWRU
%DWWHU\
&+VHUYR
<KDUQHVV
%

FUTABA 10J Specifications

General

Channels	10
Frequency	2.4GHz
Model Memory	30
Display	LCD
Telemetry	Yes
Trainer Port	Yes
Modulation	S-FHSS