92
Commonfunction
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe+key
for1second.
+
② Select
fromthemenuwiththeJog
key.
③Openthesettingscreenby
pressingtheJogkey.
(1second)
Callingthesettingscreen
Transmission of model data is possible with
T10J transmitters. Data transfer is performed by
the radio. The MDL-TRANS function works with
the current model you are using in the transmitter.
As for the receiving transmitter, any data on the
current model that is receiving the information will
be over-written.
"MDL-TRANS"
MDL-TRANS
Modeltransfer
(Common)
●
MDL-TRANSbetweentwoT10Jradiosshouldbeperformedwithin2-meterrange.
① IneachT10J,the+ or −keyispressedanditis
made"TRANSFER"and"RECEIVE".
+ −
or
● "TRANSFER":T10Jofdataorigin
"RECEIVE":T10Jwhichreceivesdata
Selectionrange:TRANSFER,RECEIVE
② Select"Execute"withtheJogkey.
③ HolddowntheJogkey[eachT10J].
(1second)
)
● "COMPLETE"isdisplayedandthemode
transferisfinished.
Modeltransfer
● Ifdataisnotbeingtransmitted,thereceivingtransmitter
returnstonormaloperation10secondsafterexecution.At
thistime,"Failure"(nottransmitting)isdisplayed.
● FromT8JtoT10J,datatransferispossible.Inthatcase,TYPE
ofT10Jonthe"RECEIVER"sideischangedinto"T8J"by+−
key.However,datacannotbesenttoT8JfromT10J.
$OZD\VFKHFNVHUYRGLUHFWLRQSULRUWRHYHU\
IOLJKWDVDQDGGLWLRQDOSUHFDXWLRQWRFRQILUP
SURSHUPRGHOGDWHKRRNXSVDQGUDGLRIXQFWLRQ
NOTE:
MDL-TRANS between two T10J radios should
be performed within a 2-meter range.
CAUTION
0'/75$16
MODE:
TRANSFER(T10J ofdata
origin)/
RECEIVE(T10J which
receivesdata)
Executionoftransmission/
reception
*T10J does not carry out normal operation during data transfer.