Cleaning the Device
NOTICE
Even small amounts of sweat or moisture can cause
corrosion of the electrical contacts when connected to a
charger. Corrosion can prevent charging and data transfer.
1 Wipe the device using a cloth dampened with a mild
detergent solution.
2 Wipe it dry.
After cleaning, allow the device to dry completely.
TIP:
For more information, go to Garmin.com.sg/legal/
fit-
and-care.
Changing the Bands
You can replace the bands with new Forerunner bands or
compatible QuickFit 22 bands.
1 Use the pin tool to push in the watch pin.
2 Remove the band from the watch.
3 Select an option:
• To install Forerunner bands, align one side of the new
band with the holes on the device, push in the exposed
watch pin, and press the band into place.
NOTE: Make sure the band is secure. The watch pin
should align with the holes on the device.
• To install QuickFit 22 bands, remove the watch pin
from the Forerunner band, replace the watch pin on
the device, and press the new band into place.
NOTE: Make sure the band is secure. The latch
should close over the watch pin.
4 Repeat the steps to change the other band.
Forerunner Specifications
NOTICE
Typical value tested under Garmin’s laboratory conditions.
The actual battery life depends on the features enabled on
your device and environmental factors, such as activity
tracking, wrist-based heart rate, smartphone notifications
frequency, GPS status, internal sensors, and connected
sensors.
Device Information 47
To Next Page
Loading...
Need help?
General
Weight and Dimensions
