1GTN 750: DIRECT-TO NAVIGATION
Navigating Direct-To Anywhere
You can navigate directly from your present position to any waypoint, or you can create a ight plan and then
y in sequence from one waypoint to the next. e GTN supports ight plans that include airways when you
specify airway entry and exit waypoints. Procedures such as departure procedures, arrivals, and instrument
approaches (as well as visual approaches with system soware 6.50 or later) also become part of the active ight
plan. Direct-To is the most basic
navigation method. You can pro-
ceed direct-to any waypoint or to a
waypoint that is part of a ight plan,
including a waypoint that is part of
an instrument procedure, such as a
departure, arrival, or approach.
Navigate from the present po-
sition direct-to a new waypoint
1. PRESS the button on the
bezel. e Direct-To window
appears, with the Waypoint
tab active.
2. TOUCH Select Waypoint
3. TOUCH the letters and num-
bers to enter the name in the
Waypoint Identier window.
Or use the Large and Small
knobs to move the cursor,
and select letters and num-
bers.
4. TOUCH Enter, and review
the waypoint name and details.
e full waypoint name appears with bearing and
distance information. If you made a mistake and need
to re-enter the waypoint, TOUCH the waypoint name
again and follow the procedure above, or TOUCH
Cancel and start over.
5. If the waypoint is correct, TOUCH the Activate
control in the lower-right of the display (or press
the Small knob).
e Map page appears with a magenta line drawn
from your present position to the waypoint you chose.
TIP
If the GTN is already navigating to a waypoint, that
waypoint appears by default in the Direct-To win-
dow. To change it, TOUCH that waypoint name,
and then use the keypad to enter a new direct-to
waypoint.
To Next Page
Loading...
Need help?
General