Clear Events
No
By using the (5) or (6) key, Clear Event Records can be set as Yes /
No.
(set ‘Yes’ to clear event data stored in memory)
Clear Faults
No
Editable setting
By using the (5) or (6) key, Clear Fault Records can be set as Yes /
No.
(set ‘Yes’ to clear Fault data stored in memory)
Clear Dist Recs
No
Editable setting
By using the (5) or (6) key, Clear Disturbance Records can be set
as Yes / No.
(set ‘Yes’ to clear Disturbance Record data stored in memory)
Clear Maint
No
By using the (5) or (6) key, Clear Maintenance Records can be set
as Yes / No.
(set ‘Yes’ to clear Maintenance Record data stored in memory)
Thermal Reset
No
Editable setting
By using the (5) or (6) key, Thermal Reset can be set as Yes / No.
(set ‘Yes’ to reset Thermal State to zero)
2.3.11 Communication Menu
2.3.11.1 View/Edit Settings
COMMUNICATION
Password protected window for “COMMUNICATION” settings :
RP1 Address, RP1 Baud Rate, RP1 Parity and RP1 Timesync.
RP1 Address
1
Editable setting
By using the (5) or (6) key, the desired RP1 Address can be set. The
setting range is from 1 to 247 in steps of 1.
RP1 Baud Rate
57600
By using the (5) or (6) key, the desired RP1 Baud Rate can be set as
9600 / 19200 / 38400 / 57600
RP1 Parity
Even
Editable setting
By using the (5) or (6) key, the desired RP1 Parity can be set as
Even / Odd / None.
RP1 Timesync
Disabled
Editable setting
By using the (5) or (6) key, RP1 Timesync can be Enabled / Disabled
To Next Page
Loading...
Need help?
General
