COLD LOAD PICKUP
Password protected window for
i.e. tcold Time Delay,
tclp Time Delay, I>1 Status, I>2 Status, I>3 Status, IN1>1 Status, IN1>2
Status, IN1>3 Status, IN2>1 Status, IN2>2 Status and IN2>3 Status.
Note: Setting will be seen only when it is enabled in Configuration
setting.
UNDERCURRENT
Password protected window for
i.e. I< Status, I< and tI<.
Note: Setting will be seen only when it is enabled in Configuration
setting.
CB FAIL
Password protected window for CB FAIL i.e. CB Fail Status, CB Fail
Timer, CB Reset, I<, IN<, Remove I> Start and Remove IN> Start.
Note: Setting will be seen only when it is enabled in Configuration
setting.
2.3.16.2 Group1 –System Configuration Submenu
2.3.16.2.1
Edit Settings
(if 2
nd
harmonic is disabled)
GROUP 1
Password protected window for “GROUP 1’’ settings:
SYSTEM CONFIG, OVERCURRENT, NEG SEQUENCE O/C, BROKEN
CONDUCTOR, EARTH FAULT 1, EARTH FAULT 2, THERMAL
OVERLOAD, COLD LOAD PICKUP, UNDERCURRENT and CB FAIL.
Note: Group 1 Setting will be seen only when it is enabled in
Configuration setting.
SYSTEM CONFIG
Password protected window for System Configuration i.e. 2nd
Harmonic (Disabled/Enabled), 2ndHarm Thresh and I>lift 2H.
2nd Harmonic
Disabled
Editable setting
By using the (5) or (6) key, 2nd Harmonic is Disabled.
2.3.16.2.2
Edit Settings
(if 2
nd
harmonic is enabled)
GROUP 1
Password protected window for “GROUP 1’’ settings:
SYSTEM CONFIG, OVERCURRENT, NEG SEQUENCE O/C, BROKEN
CONDUCTOR, EARTH FAULT 1, EARTH FAULT 2, THERMAL
OVERLOAD, COLD LOAD PICKUP, UNDERCURRENT and CB FAIL.
Note: Group 1 Setting will be seen only when it is enabled in
Configuration setting.
SYSTEM CONFIG
Password protected window for
i.e. 2nd
Harmonic (Disabled/Enabled), 2ndHarm Thresh and I>lift 2H.
2nd Harmonic
Enabled
Editable setting
By using the (5) or (6) key, 2nd Harmonic is Enabled.
To Next Page
Loading...
Need help?
General
