To Next Page

To Previous Page

PACE Series SCPI Manual

K0472 Revision A 4-91

:SOUR:PRES:RANG

Applicability: PACE5000, PACE6000

Command Syntax

:SOURCe[x][:PRESsure]:RANGe <string>

where x = 1 or 2 is the module number

(default - 1)

Parameter: <string> range information

Short form: :SOUR:RANG

Function: Selects the control range.

Query Syntax

:SOURCe[x][:PRESsure]:RANGe?

where x = 1 or 2 is the module number

(default - 1)

Short form:: SOUR:RANGE?

Function: Asks for currently selected controller range.

Response: String representing selected sense range.

Description

This command selects the range to be used for controlling pressure.

e.g. : SOURe:RANGe “2.0bara”

selects the 2 bar absolute range; the pressure units are always in bar.

Note:

Absolute ranges are pseudo-absolute values, combining barometric and gauge sensor

readings.

Example

TX> :SOUR:PRES:RANG?

RX> :SOUR:PRES:RANG "3.50barg"

Queries current range

Can set to another range:

TX> :SOUR:PRES:RANG "4.50bara"

TX> :SOUR:PRES:RANG?

RX> :SOUR:PRES:RANG "4.50bara"

This change can be observed on front panel display.

The parameter is case sensitive.

GE PACE6000 Technical Manual

Other manuals for GE PACE6000