GE Vivid E95 User Manual

System Setup
3-40 Vivid E80/E90/E95 – Service Manual
GC091052
Rev. 3
Wired Ethernet from Vivid E80/E90/E95 to a workstation
Either of these situations may apply:
• Direct Cable Connection from Vivid E80/E90/E95 to a
workstation via a Crossover Cable.
You will only need a Crossover Cable for the connection.
a. Connect one end of the Crossover Cable to the network
connector on the Vivid E80/E90/E95.
b. Connect the other end to the network connector on the
Workstation.
• Connection via a Peer-to-Peer network.
You will need a network hub and one network cable for each
Ultrasound system / workstation
• Connection via Hospital Network.
You will need one network cable to connect the Vivid E80/
E90/E95 to a wall outlet on the hospital’s network.
Connection from Vivid E80/E90/E95 to a DICOM Server on a network
You will need one network cable.
1. Connect one end of the cable to the Ethernet connector on
Vivid E80/E90/E95.
2. Connect the other end of the cable to the wall outlet.
NOTE: If a Peer-to-Peer network is connected to the hospital’s network,
you may connect the Vivid E80/E90/E95 to the Peer-to-Peer
network.

GE Vivid E95 Specifications

General

Brand	GE
Model	Vivid E95
Category	Medical Equipment
Language	English