Replacement Procedures
8-10 Vivid E80/E90/E95 – Service Manual
GC091052
Rev. 3
Remove the side covers
NOTE: The removal procedure is easier if the rear lock is released first,
and then the front lock.
The Side Covers are “clicked” on to the Ultrasound system with
two locks, located at the lower end of the cover. Two rectangular
holes give access to the locks. By inserting a #1 Phillips
screwdriver (10 - 16 cm / 4 - 6 inch length) (or similar size and
length tool) into the holes and bending the handle on the
screwdriver down to the floor, one lock at a time, you can
release the locks. You may need to pull the cover outwards at
the same time, to release the lock mechanism.
Follow these steps to remove one of the side covers:
1. Push a #1 Phillips screwdriver into one of the rectangular
holes in the Side Bumper until it reaches the lock
mechanism.
2. Push the handle on the screwdriver downwards to release
the lock.
3. Repeat the steps above for the other lock.
4. Lift the cover forward and up to remove it.
5. Set it away on a safe place until you need it again.
6. Repeat the steps above to remove the other side cover.
Install the side covers
Follow these steps to install the side covers:
1. Align tabs at the top inside of side cover with the slots on top
cover.
2. Place the top edge of the side cover so it hooks onto the top
cover.
3. Align and squeeze the front edge of the side cover to latch it
into place.
4. Position the side cover’s side lock first.
5. Position the side cover’s front lock.
6. Align and squeeze the bottom front of the side cover to latch
it into place.
7. Position the side cover’s rear lock, lifting up the rear tab and
guiding it into place.
8. Align and squeeze the bottom rear of the side cover to latch
it into place.
To Next Page
Loading...
Need help?
General
