GE Vivid E95 User Manual

Replacement Procedures
8-30 Vivid E80/E90/E95 – Service Manual
GC091052
Rev. 3
Remove the 19” LCD Monitor’s Cables Cover
A cover at the rear side of the LCD Monitor assembly covers the
two cables to the monitor. To get access to the cable
connectors, remove the Cable Cover.
Follow these steps to remove the Cable Cover:
1. For easy access, tilt the LCD Monitor forward to horizontal
position.
2. Unscrew the service screw on the top of the LCD Monitor
assembly.
3. Remove the Monitor Cables Cover.
4. Lift the cover away and place it on a safe place.
Disconnect the 19” LCD Monitor Cables
Follow these steps to remove the cables:
1. Disconnect the three signal cables.
2. Remove the cable clips, if present.
Remove the 19” LCD Monitor assembly
Follow these steps to remove the LCD Monitor assembly
1. Loosen the four screws by turning each screw between one
half and one turn counter-clockwise.
You don’t need to remove the screws.
2. Lift the LCD Monitor assembly upwards until you can lift it
away from the Monitor Bracket.
3. Place the LCD Monitor on a clean and safe surface.
Install the 19” LCD Monitor assembly
Follow these steps to install the LCD monitor:
1. Install the LCD Monitor assembly on the Monitor Bracket.
Verify that all four fixing screws have engaged in their slots.
2. Tighten the four screws.
3. Connect the cables.
4. Install the cable clips, if you removed any earlier.
5. Install the Monitor Service Cover and fasten it with the two
fixing screws.
6. Tilt the monitor to horizontal position.

GE Vivid E95 Specifications

General

Type	Cardiovascular Ultrasound System
Transducers	2D, 3D, 4D
Display	22-inch high-resolution OLED monitor
Portability	Cart-based
Imaging Modes	2D, 3D, 4D, Color Doppler
Advanced Features	cSound Architecture
Connectivity	DICOM, USB, Ethernet
Applications	Cardiology, Vascular, Abdominal