GMV5 Home DC Inverter Multi VRF Units
116
Communication
malfunction
between indoor
unit and the
receiver board
Overflow
distribution of IP
address
Remote
emergency
shutdown
Eliminate the
long-distance
shielding
command of
indoor unit
Outdoor
unit
connection
pipe length
correction
4.5.2 Table of Malfunction Codes for Hydro Box
Malfunction of water flow switch
Hydro box network
address error
Power supply
over-current
protection
Abnormal rotation speed of EC
DC water pump
Wired controller PCB
error
Malfunction of floor heating
shunt valve setting
Malfunction of upper
water temperature
sensor
Indoor unit PCB malfunction
Malfunction of
backwater temperature
sensor
Malfunction of lower water
temperature sensor
Malfunction of hydro
box water inlet
temperature sensor
Inconsistent
number of
group-controlled
hydro boxes
Malfunction of refrigerant inlet
tube temperature sensor
Malfunction of hydro
box water outlet
temperature sensor
Inconsistent
series of
group-controlled
hydro boxes
Malfunction of refrigerant outlet
tube temperature sensor
Special code: project
commissioning code
Models of hydro
box and outdoor
unit are not
matched
Malfunction of solar
power temperature
sensor
4.5.3 Table of Commissioning Codes
Wrong outdoor unit capacity code/
jumper cap setting
Ineffective refrigerant
charging
Rated capacity
ratio is too
high.
Power phase sequence protection
Compressor
emergency operation
DIP switch is wrong.
Rated capacity
ratio is too low.
Refrigerant shortage protection
Communication failure
between indoor and
outdoor units, indoor
units and wired
controllers
Malfunction
due to multiple
master control
units
Wrong compressor drive board
address
Communication failure
between main control
board and inverter
compressor drive
DIP switch
conflict of
system
address
Warning against valve error
Communication failure
between main control
board and variable
Malfunction
due to multiple
master wired