PNEG-750-G2 16" Series II Sweep 131' and 135' Diameter 17
4. General Product Information
Product Information
A. The Series II Sweep includes the following components.
• Control panel
• Two (2) motors
•Motor covers
• Motor mount
• Auger flighting
• Auger back shield assembly
• Jack supports
B. The unit will operate only in a round grain bin equipped with a center sump in the bin floor.
General Information
A. GSI reserves the right to improve its product whenever possible and practical to do so. We reserve
the right to change, improve and modify products at any time without obligation to make changes,
improvements and modifications on equipment sold previously.
B. This new bin sweep auger has been engineered and manufactured to give years of dependable
service. The care and maintenance of this equipment will affect the satisfaction and service
obtained. By following the instructions and recommendations, the owner should receive quality
service for many years. If additional information or assistance is required, please contact GSI.
C. It is important to check both the quantity of parts and their descriptions with the packing list
enclosed within each package. All claims for freight damage or shortage must be made by the
consignee within ten (10) days of the date of the occurrence. The consignee should accept the
shipment after noting the damage or loss on the bill of lading.
D. The Chart below shows radius dimensions locating the points of contact between the sweep and
the bin floor. The dimensions may be used to figure material quantities of track to support the
sweep across the aeration flooring. The track material is not supplied with the sweep and must be
supplied by the installer. The dimensions are approximate and the assembled sweep should be
checked for exact points of contact.
Radius Dimensions from Center of Bin
Bin
Diameter
# of
Sections
Head
Jack
Wheel
2" Wide
Intermediate
Jack Wheel
3" Wide
Intermediate
Jack Wheel
3" Wide
Intermediate
Jack Wheel
3" Wide
Inside
Tire 18"
Wide
Outside
Tire 18"
Wide
Extension
Jack Wheel
3" Wide
Extension
End Caster 2"
Wide Wheel
131' 6 92" 236" 380" 468" 537-1/4" 574-1/2" 677" 762-3/8"
135' 6 92" 236" 380" 484" 561-1/4" 598-1/2" 701" 786-3/8"
This Series II Sweep is a single pass sweep. Consult the manufacturer of the
storage tank regarding the requirements or restrictions of the sweeping process.
The manufacturer may require a multiple pass sweep.
NEVER enter a grain bin unless ALL power driven equipment has been shut down.
Disconnect and lock out power before entering the bin or servicing the equipment.
To Next Page
Loading...
Need help?
General
