To Next Page

To Previous Page

64 PNEG-750-G2 16" Series II Sweep 131' and 135' Diameter

9. Maintenance

Maintain the Auger

A. Use caution when repairing or replacing equipment parts.

B. Make sure ALL decals are legible and securely attached to the auger. If necessary, replace them

FREE OF CHARGE by contacting GSI at:

GSI

1004 E. Illinois St.

Assumption, IL. 62510

Phone: 1-217-226-4421

C. Ensure that ALL electric motors, etc., are operating at the proper speed.

D. Make sure ALL electrical wiring is not damaged and that it meets proper wiring codes.

E. Make sure ALL components are in good working condition before use.

ALWAYS shut down and disconnect the power supply before adjusting,

servicing or cleaning the equipment.

ALL SPEED REDUCERS ARE SHIPPED DRY. OIL MUST BE ADDED PRIOR TO

OPERATION. Do not operate the unit without making sure it contains the correct

amount of oil. Do not overfill or underfill with oil or injury to personnel, unit or

other equipment may result.

Do not mix non-synthetic and synthetic oil in the unit.

Other manuals for GSi Sweep II Series

Questions and Answers:

Need help?

Do you have a question about the GSi Sweep II Series and is the answer not in the manual?

General