To Next Page

To Previous Page

5. Assembly

PNEG-750-G2 16" Series II Sweep 131' and 135' Diameter 39

Motor Installation

A. Level the top plate assembly by adjusting the 1" nuts and washers on the adjustment rods.

(See Figure 5W.)

B. Line up the end face of the shafts as closely as possible before bolting motor to mounting plate.

(See Figure 5W-A.)

Figure 5W

C. Fasten the motor to the motor mount using hex bolts, lock washers and hex nuts. (See Motor Bolt

Chart for bolt sizes.)

Motor Bolt Chart

Motor Size Hex Bolt Size Qty

213T 3/8"-16 x 1-1/4" 4

215T 3/8"-16 x 1-1/4" 4

254T 1/2"-13 x 1-3/4" 4

256T 1/2"-13 x 1-3/4" 4

284T 1/2"-13 x 1-3/4" 4

286T 1/2"-13 x 1-3/4" 4

Motor bolt

(See chart below for size)

Other manuals for GSi Sweep II Series

Questions and Answers:

Need help?

Do you have a question about the GSi Sweep II Series and is the answer not in the manual?

General