6 - Menu 2 Setup
32
Menu 2.2 Auto functions
Menu 2.2.1 Main ON/OFF
The Controller can be set to open the main ON/OFF function above a certain speed and close it below the same speed. This
allows the user to concentrate on driving. If the speed is set at zero the function is deactivated. Suggested speed setting is
spraying speed less 20%.
When the Auto ON/OFF is active and the main switch and boom section switches are on, the boom status symbol on the
1st line will blink when speed is under the trigger value.
±
WARNING! Remember to set the main ON/OFF switch to OFF before leaving the field, otherwise the main ON/OFF
will open under transport.
Menu 2.2.2 Foam Marker (optional)
The Controller can be set to operate the HARDI Foam marker automatically through the main ON/OFF valve. When the main
ON/OFF is ON, it will automatically start the Foam marker.
Furthermore, the Foam marker can be set for up and back spraying or race-track (round and round) spraying.
Foam marker status is shown briefly on the line 4 of the screen.
Menu 2.2.3 Dual line (optional)
If the sprayer is fitted with 2 sets of boom lines this function can be used to ensure volume rate and droplet size is maintained
during large changes to forward speed.
The boom lines are pronounced A and B.
System options:
Menu 2.2.3.1:
Here the lower limit are selected. Depending on the setup, either speed or pressure can be the trigger for changing between
the steps.
Menu 2.2.3.2:
Here the upper limit are selected. Depending on the setup, either speed or pressure can be the trigger for changing
between the steps.
μ
ATTENTION! Note this menu is only shown if Jobcom hardware is fitted, and the software is enabled.
Setting Activity
[Disable] The marker will only follow the setting of the switch on the Spray Box.
[Same side] The Controller will automatically activate the same side for race-track spraying.
[Change side] The Controller will automatically change side for up and back spraying.
2 step: A to B
3 step: A to B to A&B
To Next Page
Loading...
Need help?
General
