8 - Menu 4 Toolbox
54
Menu 4.2 Service intervals
Menu and intervals
Service intervals and a nozzle check are programmed into the Controller. This makes it easier for the operator to remember
the service intervals.
From the factory, the Controller is set up with three service and a nozzle check reminder.
Entering the above menu’s will display the hours remaining until next service. The importer or dealer may have added a
“Miscellaneous service” Interval. If no interval is set, [Miscellaneous service not defined] is shown.
Press to register service or control, if displayed when switched on. The warning will remain present until the service
interval is reset.
Service interval reset
To reset service interval, go to relevant interval menu listed:
Press to reset hour meter.
Press to confirm.
Menu & interval Hours Action
[4.2.1 Check filters] 10 See sprayer instruction book, Maintenance.
[4.2.2 Grease boom] 50 See sprayer instruction book, Maintenance.
[4.2.3 Grease track and centre] 250 See sprayer instruction book, Maintenance.
[4.2.4 Miscellaneous service] - Not defined from factory.
[4.2.5 Check nozzles] 50 Check flow rate. Change nozzles if more than 10% of rated flow.
Menu & interval Hours Action
[4.2.1 Check filters reset] 10 See sprayer instruction book, Maintenance.
[4.2.2 Grease boom] 50 See sprayer instruction book, Maintenance.
[4.2.3 Grease track and centre] 250 See sprayer instruction book, Maintenance.
[4.2.4 Miscallaneous service] - Not defined from factory.
[4.2.5 Check nozzles] 50 Check flow rate. Change nozzles if more than 10% of rated flow.
To Next Page
Loading...
Need help?
General
