Hikvision USA, Inc. – Series DS-7300 User Manual
Configuring Video Loss Detection
Video loss detection can be enabled on any of the channels on your DVR to detect the loss of video.
To configure video loss detection:
1. Enter the Video Loss Detection menu, shown in Figure 49 by going to Main Menu > Camera Setup > Video
Loss Detection.
Figure 49. Video Loss Detection Menu
2. Select the camera to setup video loss detection in using the camera drop down menu on the upper left of the
menu. If all cameras are to be configured with the same settings, select All Cameras from the list.
3. Click Enable Video Loss Detection.
4. Select Actions to take if video loss is detected. More than one action can be selected per channel. These
actions include:
• Sound Audio Warning: DVR will sound an audio warning if video loss is detected.
• Pop-up Image on Monitor: DVR will show the corresponding channel that is associated with the video loss
channel.
• Notify Surveillance Center: DVR will notify surveillance center when video loss is detected.
• Send Email: DVR will send an email out to the designated recipients when video loss is detected.
• Trigger Alarm Output: DVR will trigger alarm output when video loss is detected. Selecting this option will
enable the Alarm Output list, where the output to trigger can be selected.
5. Select the Save button to save the privacy zones settings and select Exit to return to the previous menu.
Selecting the Exit button without clicking Save will quit out of the menu without saving settings.
To Next Page
Loading...
Need help?
General