Hikvision USA, Inc. – Series DS-7300 User Manual
Managing Disks
Checking Disk Status
The status of all installed hard disk drives (HDD) can be checked under the Disk Management menu.
To check the status of installed disks:
1. Enter the Disk Management menu, shown in Figure 51 by going to Main Menu > System Configuration >
Disk Management.
Figure 51. Disk Management Menu
2. There are three different panels found in the Disk Management menu. They include:
• Disk Utilization: Displays the maximum space available of all disks combined.
• Available Disks: Displays a list of all installed disks and their respective space and status.
• Status: Displays the available disk space of all disks combined.
3. Click the Done button to exit out of Disk Management.
Formatting Disk
A newly installed hard disk drive (HDD) must be first formatted before it can be used with your DVR. Formatting
the disk will erase all data on it.
To format a new disk:
1. Enter the Disk Management menu, shown in Figure 51 by going to Main Menu > System Configuration >
Disk Management.
2. Select a disk to format. A disk that has not been formatted will show Error Detected as its status. If the disk
is one that is newly installed, the status of drive will show up as Non-Active and the Reformat button will change
to the Add button.
3. Click the Reformat/Add button.
4. A confirmation message, similar to the one shown in Figure 52 will appear on the screen. Click the Yes
button to continue formatting process.
Figure 52. Disk Format Confirmation
To Next Page
Loading...
Need help?
General