HIKVISION DS-K1T341C Series User Manual

3) Click Add to save the recorded ngerprint.
7.
Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and
connue to add other persons.
Note
Once the ngerprint is added, the ngerprint type cannot be changed.
9.4.8 Collect Fingerprint via Access Control Device
When adding person, you can collect ngerprint informaon via the access control device's
ngerprint module. The ngerprints recorded can be used as credenals of the persons to access
the authorized doors.
Before You Start
Make sure
ngerprint collecon is supported by the access control device.
Steps
1.
Enter Person module.
2.
Select an
organizaon in the organizaon list to add the person and click Add.
Note
Enter the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Basic Informaon .
3.
In the Credenal → Fingerprint panel, click +.
4.
In the pop-up window, select the
collecon mode as Remote.
5.
Select an access control device which supports ngerprint recognion funcon from the drop-
down list.
6.
Collect the
ngerprint.
1) Click Start.
2) Place and li your ngerprint on the ngerprint scanner of the selected access control device
to collect the ngerprint.
3) Click Add to save the recorded ngerprint.
7.
Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and
connue to add other persons .
Note
Once the ngerprint is added, the ngerprint type cannot be changed.
DS-K1T341C Series Face Recognion Terminal User Manual
143

HIKVISION DS-K1T341C Series Specifications

General

Brand	HIKVISION
Model	DS-K1T341C Series
Category	Touch terminals
Language	English