To Next Page

To Previous Page

PC running the client by USB interface or COM, and place the card on the card enrollment to read

the card number. If not, you can also swipe the card on the card reader of the added access control

device to get the card number. As a result, before issuing a card to one person, you need to set the

card issuing parameters including the issuing mode and related parameters.

When adding a card to one person, click Sengs to open the Card Issuing Sengs window.

Local Mode: Issue Card by Card Enrollment Staon

Connect a card enrollment staon to the PC running the client. You can place the card on the card

enrollment

staon to get the card number.

Card Enrollment

Staon

Select the model of the connected card enrollment staon

Note

Currently, the supported card enrollment staon model is DS-K1F180-D8E.

Card Type

Select the card type as EM card or IC card according to the actual card type.

Buzzing

Enable or disable the buzzing when the card number is read successfully.

Card No. Type

Select the type of the card number according to actual needs.

M1 Card Encrypon

If the card is M1 card, and if you need to enable the M1 Card Encrypon funcon, you should

enable this

funcon and select the sector of the card to encrypt.

Remote Mode: Issue Card by Card Reader

Select an access control device added in the client and swipe the card on its card reader to read

the card number.

9.5

Congure Schedule and Template

You can congure the template including holiday and week schedule. Aer seng the template,

you can adopt the congured template to access groups when seng the access groups, so that

the access group will take

eect in the me duraons of the template.

Note

For access group sengs, refer to Set Access Group to Assign Access Authorizaon to Persons .

DS-K1T341C Series Face Recognion Terminal User Manual

152

HIKVISION DS-K1T341C Series User Manual

Questions and Answers: