Fingerprint Access Control Terminal·User Manual
10
Chapter 4 Basic Operation
The suggested working flow is as follows:
Device Activation: Activate the device before first using.
Login: Hold the OK button for 3s to login the device main interface.
Parameters Configuration: Configure the communication, the system, and the time.
User Management: Add, edit and delete the users in the fingerprint access control terminal. You
are able to set the user ID No. name, card number fingerprint, password, department, etc.
Access Control Configuration: Configure the access control parameters and control the door
status.
Attendance Configuration: Configure the attendance parameters and control the users
attendance.
Note: The device has configured the default department, the default shift, the default shift
schedule and the default system information. You are able to use the device directly after adding
the user.
4.1 Device Activation
Purpose:
You should activate the device before the first login. After powering on, the system will switch to
Device Activation interface.
Activation via the device, SADP tool and the iVMS-4200 client software are supported.
The default values of the terminal are as follows:
The default IP address: 192.0.0.64
The default port No.: 8000
The default user name: admin
4.1.1 Activating via Device
If the device is not activated before first login, the system will enter the Device Activation interface
after powering on.
To Next Page
Loading...
Need help?
General
