HIKVISION DS-PHA20-P User Manual

4. Enable Zone Bypass and the zone will be in the bypass status.
The detector in the zone does not detect anything and you will not receive any alarm from the
zone.
4.3.11 Set Zone
Aer the detector is added, you can set the zone, including the zone name, the zone type, zone
bypass, linked camera, stay/away status, the sounder, and the silent zone. You can also view the
detector serial No. (only device in 433 HMz) and the detector type of the zone.
Steps
1. On the device list page, tap the security control panel and then log in to the device (if required)
to enter the control panel page.
2. Tap Zone and then tap a zone in the Area page to enter the zone
sengs page.
Figure 4-50 Zone Seng Page
3. Set the following parameters as you desired.
Zone Type
Select a zone type from the zone type list.
If you select Delayed Zone, you should select an entry delay (Entry Delay 1 or Entry Delay 2)
on the pop-up page.
If you select Timeout Zone, you should select a
meout value or tap Custom to set a custom
value.
Zone Bypass
Hybrid Security Control Panel User Manual
75

HIKVISION DS-PHA20-P Specifications

General

Brand	HIKVISION
Model	DS-PHA20-P
Category	Control Panel
Language	English