Network Traffic Camera • User Manual
54
10.2 Configure General Parameters
Purpose:
General parameters refer to the image parameters applying to both video image and capture
image, such as saturation, sensitivity, lens type, sharpness, white balance, gamma correction, and
brightness enhancement.
Step 1 Go to Configuration > Device Configuration > Image Parameters > General Parameter.
Figure 10-2 General Parameters Configuration
Step 2 Set the image Saturation, Sharpness and White balance mode.
Saturation describes the colorfulness of the image color, which ranges from 0 to 100.
Sharpness describes the edge contrast of the image, which ranges from 1 to 100.
White Balance is the white rendition function of the camera used to adjust the color
temperature according to the environment.
Step 3 Select Iris Mode. Auto and Manual are selectable.
Step 4 Adjust Brightness Enhancement at Night. It ranges from 0 to 100.
Step 5 (Optional) Check Image Rotation and select Rotation Angle according to actual installation.
Step 6 (Optional) Check Light Compensation on License Plate. Adjust the sensitivity to 0 to 100 if you
enable the function.
Step 7 (Optional) Check Enable Gamma Correction, and adjust the correction level from 0 to 100.
Gamma correction can enhance picture contrast, but bring noise at the same time.
Step 8 (Optional) Check Enable Light Compensation Correction to adjust the license plate brightness
automatically if the license plate or scene brightness cannot be adjusted via supplement light.
And adjust Correction Level from 0 to 100.
To Next Page
Loading...
Need help?
General
