HIKVISION iDS-TCV907-BER Configuration Manual

Figure 2-2 Manual Calibraon
3.
Draw the lane lines.
1) Select the lane sum.
2) Select the lane line No.
3) Click Draw Lane Line.
The selected lane line will be displayed on the live view picture.
4) Drag the two end points of the line or drag the whole line to adjust its
posion according to
the actual scene.
5) Repeat the steps above to draw more lane lines.
4.
Draw the
calibraon area.
1) Select Calibraon Point.
2) Click Calibraon.
3) Click the
le buon of the mouse to locate the vertexes of the calibraon area on the live
view image, and click the right buon of the mouse to nish the drawing.
Note
The number of vertexes should be consistent with the selected number of Calibraon Point.
4) Drag the vertexes of the calibraon area to align it to the lanes.
Note
●
If the lanes cannot be aligned, ensure the calibraon area can contain the detecon area.
●
You can refer to the schemac diagram and top view descripon to draw the calibraon
area.
5) Oponal: Click Clear to clear the drawn calibraon area.
5.
Measure the world coordinates of the vertexes, and enter the values in the corresponding
coordinate text
elds.
Network Trac Camera Conguraon Manual
67

HIKVISION iDS-TCV907-BER Specifications

General

Brand	HIKVISION
Model	iDS-TCV907-BER
Category	Security Camera
Language	English