Honeywell LYNX Touch Series User Manual

LYNX Touch Installation and Setup Guide
- 39 -
Programming the Control
Sounder
The following system options are programmed in this section:
Option Function
Burglary Alarm Sound Switches the full 110 dB alarm sound for burglary On/Off.
Burglary Bell Timeout Select the time for timeout of the Burglary Alarm sounder.
Fire Bell Timeout Select the time for timeout of the Fire Alarm sounder.
Arm Confirm Enable sounder “ding” when system is armed via the selected RF device.
Alarm Options Select a limit for the number of times an alarm can sound for a specific zone.
Note: This option does not apply to the LYNX Touch SIA control.
Note: If applicable, preprogrammed defaults for the LYNX Touch Control are shown on the screen unless otherwise noted.
SCREEN ACTION
Sounder
Select “Sounder”
The System displays the following options:
Burglary Alarm Sound Burglary Bell Timeout
Fire Bell Timeout Arm Confirm
Alarm Options
Burglary Alarm Sound
Yes
Select “Burglary Alarm Sound”. The System toggles between Yes* and No:
Burglary Bell Timeout
4 Minutes
Select “Burglary Bell Timeout”. The System scrolls between the following options:
No
4 Minutes
8 Minutes
12 Minutes
16 Minutes
Fire Bell Timeout
4 Minutes
Select “Fire Bell Timeout”. The System scrolls between the following options:
No
4 Minutes
8 Minutes
12 Minutes
16 Minutes
Arm Confirm
None
Select “Arm Confirm”. The System scrolls between the following options:
None
All RF
RF Key Fob
RF Keypad
Alarm Options
Unlimited
Note: This option does not apply to the LYNX Touch SIA Control.
Select “Alarm Options”. The System scrolls between the following options:
Unlimited
1
2
10
Select “Save”.

Honeywell LYNX Touch Series Specifications

General

Brand	Honeywell
Model	LYNX Touch Series
Category	Security System
Language	English