LYNX Touch Installation and Setup Guide
- 59 -
System Operation
Central Station Messages
The following messages are sent by the L5100 communications modules (GSMVLP5-4G/GSMVLP5CN4G, ILP5 and
L5100-WiFi) for the conditions listed below.
Alarm Condition Alarm Code Restore Code
Power On / Reset E339 C0803
Primary Communication Path Supervision E350 C0951 R350 C0951
Secondary Communication Path Supervision E350 C0952 R350 C0952
Test 5555 5555 9
The control panel sends its own general code (E353) for a trouble condition. The Control panel sends tamper trouble
(E341), tamper alarm (E145), power loss (E301) and low battery (E302) messages.
To Next Page
Loading...
Need help?
General
