Honeywell SRX User Manual

Attaching the SRX2/SRX3 to a Hard Hat
With an SRX2/SRX3 Hard-Hat Headset clip mounted on the side of a hard hat, the head-
set's fork and disk assembly snaps securely onto the hat.
1. Insert the disk into the hard-hat clip from the top.
2. Slide the disk into the clip until it snaps into place.
To remove the headset, apply pressure to the tab at the top of the hard-hat clip to release
the disk from the clip. Then slide the disk up and out of the clip. It may be necessary to
use a tool, such as a flat-head screwdriver, to press the tab.
Wearing the SRX2/SRX3 Hard-Hat Headset
The SRX2/SRX3 Hard-Hat Headset fork and disk assembly has two lock positions that
allow for easy wearing, removing and storing the hard hat with the headset attached. The
inner position keeps the earcup snug to the ear; the outer position enables the headset to
be swiveled in the clip without causing wear to headset parts or to the hard hat.
1. Hold the hard hat firmly.
2. Push the headset earcup in toward the head area of the hat until it snaps
into its inner position.
SRX3 User Guide - Preliminary 30

Honeywell SRX Specifications

General

Brand	Honeywell
Model	SRX
Category	Headsets
Language	English